Managing a Cisco Internetwork MCQs

Question 1

You telnet to a router and make your necessary changes; now you want to end the Telnet session. What command do you type in?

Accepted Answer

exit

Answer

close

Answer

disable

Answer

disconnect

Question 2

Which command displays the configuration register setting?

Accepted Answer

show version

Answer

show ip route

Answer

show boot version

Answer

show flash

Question 3

What should the configuration register value be after you successfully complete the password recovery procedure and return the router to normal operation?

Accepted Answer

0x2102

Answer

0x2100

Answer

0x2101

Answer

0x2142

Question 4

You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?

Accepted Answer

You must use the terminal monitor command.

Answer

You must type the show ip rip command first.

Answer

IP addressing on the network is incorrect.

Answer

Debug output is sent only to the console.

Question 5

What does the command o/r 0x2142 provide?

Accepted Answer

It is used to bypass the configuration in NVRAM.

Answer

It is used to restart the router.

Answer

It is used to enter ROM Monitor mode.

Answer

It is used to view the lost password.

Question 6

You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?

Accepted Answer

The configuration register setting is incorrect.

Answer

You didn't boot the router with the correct command.

Answer

NVRAM is corrupted.

Answer

The newly upgraded IOS is not compatible with the hardware of the router.

Question 7

The corporate office sends you a new router to connect, but upon connecting the console cable, you see that there is already a configuration on the router. What should be done before a new configuration is entered in the router?

Accepted Answer

NVRAM should be erased and the router restarted.

Answer

RAM should be erased and the router restarted.

Answer

Flash should be erased and the router restarted.

Answer

The new configuration should be entered and saved.

Question 8

Which command will show you the IOS version running on your router?

Accepted Answer

sh version

Answer

sh IOS

Answer

sh flash

Answer

sh running-config

Question 9

You need to gather the IP address of a remote switch that is located in Hawaii. What can you do to find the address?

Accepted Answer

Issue the show cdp neighbors detail command on the router connected to the switch.

Answer

Issue the show ip arp command on the router connected to the switch.

Answer

Issue the show ip route command on the router connected to the switch.

Answer

Issue the show cdp neighbor command on the router connected to the switch.